Навигационная антенна GPS Cheyoule системы усиления сигнала для автомобилей, передатчик и приемник, 50 шт.

Brand NameCheyouleModel NameotherGPS typeReceiver & AntennaMeasurement unitset/setsEach pack5036 165,15 ₽36 165,15 ₽Add to CartBuy now36 165,15 ₽loader

Description

• -USB port GPS receiver
• -Can be used for common smart mobile phone/laptop/desktop computer/tablet PC...
• -Water resistant IP64
• -Mounting magnetic base

• -Center Frequency(MHz): 1575.42
• -Bandwidth(MHz): 6
• -Input Impendence(Ω): 50
• -V.S.W.R: <1.5
• -Consumption Electric: <15mA
• -Polarization Intensity: R.H.C.P
• -Supply Voltage: USB 5V
• -The Sound Coefficient: <1.5dB
• -Axial Ratio: 30Db
• -Gain(dBi): 29dB±3dB(LNA)
• -Operating Current: < 20mA
• -Cable Length approxi. 5M/15FT(receiver part)+ 2M/6FT(transmitter part)

• The receiver in the car by the adsorption position of the trunk; Cable into the car from the rear door or the back seat of the car door , and then go to the next floor mats beneath the center console , connect the transmitter, the transmitter is placed above the center console storage box , or , finally received through the power to work.
• -Power plug: USB plug interface provide voltage antenna, supporting Mini car cigarette lighter to USB power plug
• -Receiver: Mounted on the vehicle , the vehicle receives a strong GPS signal , and amplified for transmission to the vehicle .
• -Transmitter: Mounted in the vehicle , after the receiver amplifies the signal transmitted again transmitted to the car, so the car navigator receives the equivalent of three or four times external signal strength .

• 1. The receiving end of the upper magnets mounted outside the vehicle trunk , facing the reception .
• 2. The transmitter installed in the center console under the windshield or front passenger storage compartment , pay attention to the emitting surface ( black shell surface ) for GPS Location of the device ( navigator ) is located, and to ensure that the transmitter from GPS Less than one meter from the device , the transmitter and GPS No metal block between devices in order to achieve the best results.
• 3. After he receiver and the transmitter is installed, connect USB power partwith the cigarette lighter ( input voltage DC16V Or less ), power side indicator light , which means that work properly, then start GPS Equipment.

• 1 x Antenna transmitter
• 1 x Receiver
• 2 x for 3m glue